Mounting The Front Bezel - HP D5970A - NetServer - LCII Installation Manual

Chapter 13
Figure 13-10. Pressing in the Release Latches
11. Insert the screws through the flanges into the rack nuts and use a Torx
T-25 driver to secure the HP NetServer to the rack columns.
Each of the HP NetServer's two front flanges has two slots, which should
line up with the rack nuts previously mounted on the rack columns.
CAUTION To prevent a possible system crash when performing a Power
Supply Hot Swap, do not use older power supplies from the
HP NetServer LXr 8000. Use HP NetServer LXr 8500 part
number 0950-3663 (all revisions), or HP NetServer LXr 8000
part number 0950-2881, revisions 01, 02, or greater.
12. Re-install the power supplies into the HP NetServer.

Mounting the Front Bezel

The front bezel is attached to the HP NetServer by a hinge and a latch. The hinge
and latch must be attached to the front of the HP NetServer before mounting the
bezel.
Press in release latch
on each slide and
push the HP NetServer
into the rack.
Alternative Rack Mounting
®
161