HP D5970A - NetServer - LCII Installation Manual page 11

Chapter 1
Refer to Chapter 9, "Connecting the Monitor, Keyboard, Mouse,
and UPS."
Also connect mass storage devices or other components, including
hot swap hard drives.
Refer to Chapter 4, "Installing Mass Storage Devices."
12. Obtain the release history of the HP NetServer Navigator CD-ROM
provided with the HP NetServer, to ensure you have the latest Navigator
CD-ROM.
Refer to Chapter 10, "Configuring the HP NetServer."
13. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Indicators, and Ports."
14. Insert the HP NetServer Navigator CD-ROM and reboot the HP NetServer.
15. Check the Navigator README file for important installation information.
Refer to Chapter 10, "Configuring the HP NetServer."
16. Configure the HP NetServer with Configuration Assistant from the HP
NetServer Navigator CD-ROM, using the Express Configuration option.
Refer to Chapter 10, "Configuring the HP NetServer."
NOTE
To fully configure the HP NetServer, all the rack components
should be cabled and online, but not necessarily installed in the
rack. Use the HP NetServer LXr 8500 Rack Assembly and
Cabling Reference Guide for more details.
17. If you plan to ship a fully-configured rack system to a different destination,
label each cable and component.
a. Remove all components from the rack, including external mass
storage devices.
b. Repack the components in the original packing material, and label
them for shipment.
CAUTION It is critical to disassemble and re-box all electronic
components before re-shipment. Electronic components
(especially hard disk drives) can sustain damage when shipped
in rack enclosures.
Setting Up the HP NetServer
3