Placing The Hp Netserver In The Rack - HP D5970A - NetServer - LCII Installation Manual

Chapter 8

Placing the HP NetServer in the Rack

Use this procedure to position the HP NetServer into the extended slides and
secure the chassis to the slides.
1. Ensure you have extended the anti-tip foot from the rack, before continuing
this procedure.
WARNING
If you have not done so already, pull the rack's anti-tip foot
forward out of the bottom of the rack to prevent rack
instability while mounting the HP NetServer. Failure to do so
could result in injury and equipment damage. See Figure 8-7.
2. Pull out both slides until the slide members are fully extended.
See Figure 8-7.
The slides click into position when locked. This locked position prevents
the slides from moving back into the rack, unless the release latches are
pressed as shown in Figure 8-10.
Leveler
Screws (4)
Anti-tip Foot
Slide Member
Figure 8-7. Pulling Out the Slides
Rack Mounting the HP NetServer
Slide Member
97