Speaker; Removing The Speaker; Installing The Speaker - HP Z210 Maintenance And Service Manual

Speaker

This section describes how to remove and install the speaker.

Removing the speaker

To remove the speaker:
1. Disconnect power from the workstation (see
2.
Remove the side access panel (see
3. Remove the front bezel (see
4. Disconnect the speaker cable from the system board (1) as shown in the figure below.
5.
Remove the two screws as shown (2).
6.
Slide the speaker away from the chassis and remove it from the chassis (3).
Figure 5-20

Installing the speaker

To install the speaker, reverse the previous steps.
ENWW
Removing the side access panel on page
Removing the front bezel on page
Removing the workstation speaker
Predisassembly procedures on page
68).
Removing and installing components
62).
65).
79