Bezel
This section describes how to remove and install the front chassis bezel.
Removing the front bezel
To remove the front bezel:
1.
Remove the side access panel (see
2.
Lift the release tabs (1), and then rotate the front bezel off the chassis (2).
Figure 5-6
Installing the front bezel
To install the front bezel, align the tabs discussed in the previous section and rotate the bezel until it
snaps in place.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
68
Chapter 5 Replacing components
Removing the side access panel on page
Removing the front bezel
Removing the side access panel on page
Predisassembly procedures on page 62
65).
).
65).
ENWW