Rear System Fan Assembly; Removing The Rear System Fan Assembly; Installing The Rear System Fan Assembly; Memory Fan - HP Z600 Maintenance And Service Manual

Rear system fan assembly

This section describes how to remove and install the rear system fan assembly.

Removing the rear system fan assembly

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the memory cooling fan (see
4. Disconnect the rear system fan assembly cable
figure.
Figure 5-69
5. Press down on the ribbed portion of the rear system fan housing
, and lift the assembly out of the chassis.

Installing the rear system fan assembly

To install the rear system fan assembly, reverse these steps.
Place the assembly in the chassis at an angle, rotate it vertical until it snaps into place, and then connect
the assembly cable to the system board.

Memory fan

This section describes how to remove and install a memory fan.

Removing the memory fan

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
122 Chapter 5 Replacing components
Disconnecting fan cables
Predisassembly procedures on page
Removing the side access panel on page
Removing the memory fan on page
from the system board as shown in the following
Predisassembly procedures on page
Removing the side access panel on page
73).
75).
122)
, rotate the fan housing down
2
73).
75).
ENWW