System Fans; Removing The Rear System Fan Assembly - HP Z800 Maintenance And Service Manual

System fans

This section describes how to remove and install the front and rear system fans.

Removing the rear system fan assembly

1.
Disconnect power from the workstation (see
2. Remove the side access panel (see
3.
Remove the expansion card support (see
4. Remove the airflow guide (see
5.
Disconnect the rear system fan assembly cable connector from the system board as shown in the
following figure.
NOTE:
Figure 5-75
146 Chapter 5 Replacing components
Removing the airflow guide on page
There is a single cable connector for the dual fan assembly.
Removing the rear system fans
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
77).
79).
82).
80).
ENWW