Page of 6

HP xw8600 - Workstation Installation Manual

Esata pci cable kit installation.
Hide thumbs
   
HP eSATA PCI cable kit installation
Introduction
This kit provides components and installation instructions for adding an external SATA (eSATA) adapter
to the HP
supports up to two point-to-point eSATA connections, but does not support eSATA multipliers.
eSATA adapter
Warranty
Installation instructions
To view QuickSpecs and determine the compatibility of this product with your HP workstation, see
http://www.hp.com/go/productbulletin.
ENWW
Workstation series and HP xw6600 and HP xw8600 Workstations. The eSATA adapter
© 2007–2009 Hewlett-Packard Development Company, L.P. Printed in the U.S.
Introduction
1

Advertising

   Also See for HP xw8600 - Workstation

   Related Manuals for HP xw8600 - Workstation

   Summary of Contents for HP xw8600 - Workstation

  • Page 1: Kit Contents, Before You Begin

    Kit contents ● eSATA adapter ● Warranty ● Installation instructions Before you begin To view QuickSpecs and determine the compatibility of this product with your HP workstation, see http://www.hp.com/go/productbulletin. © 2007–2009 Hewlett-Packard Development Company, L.P. Printed in the U.S. ENWW Introduction...

  • Page 2: Warnings And Cautions

    Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area marked with this symbol. WARNING! To reduce the risk of electric shock or damage to your equipment: —...

  • Page 3: Removing Components

    Step 1—Preparing for component installation NOTE: Workstation models vary. All illustrations are examples only. Accessing the internal components of the workstation If you need help preparing the workstation for this installation, consult the removal and replacement procedures in the service guide for your workstation at http://www.hp.com/support/ workstation_manuals.

  • Page 4

    Step 2—Installing and connecting the eSATA adapter NOTE: To locate the appropriate connectors on the system board, see the service label on the workstation access panel. Insert the eSATA adapter into the selected slot with the two SATA connector cables protruding inside the workstation chassis Close the expansion slot retention clamp Figure 2...

  • Page 5

    Step 5—Setting the system BIOS for eSATA operation Workstations To access the Computer Setup (F10) Utility menu: Power on or restart the workstation. As soon as your display is active and F10=Setup appears in the lower right corner of the screen, press F10.

  • Page 6

    HP xw Workstations To access the Computer Setup (F10) Utility menu: Power up the workstation. Press as soon as your display is active and you see F10=Setup appear in the lower-right corner of the screen. NOTE: If you do not press at the appropriate time, turn the workstation off, turn it on, and then press again to access the utility.

Comments to this Manuals

Symbols: 0
Latest comments: