Download  Print this page

Cpu Heatsink; Removing The Cpu Heatsink - HP Z210 Maintenance And Service Manual

Convertible mini tower workstation.
Hide thumbs

Advertisement

NOTE:
5.
Replace all components that were removed in preparation for component installation.

CPU heatsink

This section describes how to remove and install a CPU heatsink.

Removing the CPU heatsink

To remove a heatsink:
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
Slowly and evenly loosen one pair of diagonally opposite screws (1) from the CPU until the screw
shanks disengage from the system board, and then loosen the remaining pair (2) as shown below.
CAUTION:
screws a little at a time, ensuring that the CPU remains level.
Figure 5-38
98
Chapter 5 Replacing components
Blue SATA ports (numbered zero and one) support SATA Gen 3 (6 Gbit/sec).
Do not fully loosen one screw, and then move on to the next. Instead, loosen all
Loosening heatsink screws in sequence
Predisassembly procedures on page
Predisassembly procedures on page
Removing the side access panel on page
62).
62).
65).
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z210

Comments to this Manuals

Symbols: 0
Latest comments: