Converting to desktop configuration
This workstation can be operated in the mini-tower or the desktop configuration. Follow these steps to
convert to desktop configuration operation:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Remove the front bezel from the workstation (see
4.
Press gently on the edges of the optical drive bay filler panel (1) to remove it from the front bezel
as shown in the following figure.
Figure 5-45
5.
Rotate the filler panel (2) 90 degrees to a horizontal position.
ENWW
Removing the side access panel on page
Removing the ODD bay filler panel
Predisassembly procedures on page
Removing the front bezel on page
Removing and installing components
62).
65).
68).
105