Installing An Expansion Card - HP Z210 Maintenance And Service Manual

Convertible mini tower workstation
Hide thumbs Also See for Z210:
Table of Contents

Advertisement

7.
Carefully lift the card from the chassis (3).
8.
If you are not replacing the card in this slot, install an expansion slot cover and close the
expansion card retention clamp.
If the expansion card retention clamp does not close, ensure that all cards are properly seated,
and then try again.

Installing an expansion card

Visit
http://www.hp.com/go/quickspecs
workstation, how much memory each graphics card includes, and graphics card power requirements.
To install an expansion card:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Push the expansion card retention clamp levers down on the outside of the chassis to release the
retention clamp (1) as shown in the figure below.
Figure 5-31
4.
Remove the expansion card slot cover by pulling it up, out of the chassis (2).
TIP:
the outside.
5.
Angle the card into the expansion card guide.
92
Chapter 5 Replacing components
Removing the slot cover
Grasp the slot cover between two fingers—one from the inside of the chassis, and one from
to learn which graphics cards are supported in the
Predisassembly procedures on page
Removing the side access panel on page
62).
65).
ENWW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents