System Board; Removing The System Board - HP Z210 Maintenance And Service Manual

Convertible mini tower workstation
Hide thumbs Also See for Z210:
Table of Contents

Advertisement

System board

This section describes replacing the system board.

Removing the system board

To remove the system board:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Remove expansion boards and graphics cards (see
4.
Remove the CPU heatsink (see
heatsink screws also secure the system board to the chassis.
5.
Disconnect all cabling from the system board.
TIP:
Make a note of the cable connections before disconnecting them from the system board.
For more information, refer to
6.
Remove the ten mounting screws (1) as shown in the following figure.
Figure 5-43
7.
Lift the system board slightly, and pull the board away from the rear of the chassis.
8.
Lift the system board upward out of the chassis (2).
ENWW
Removing the side access panel on page
Removing the CPU heatsink on page
Power connections on page
Removing the system board
Predisassembly procedures on page
Removing an expansion card on page
81.
Removing and installing components
62).
65).
98). Note that the CPU
90).
103

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents