HP Z210 Maintenance And Service Manual page 81

3.
Remove the front bezel (see
4. Remove the fastening screws from the I/O device assembly and remove it from the chassis as
shown in the following figure.
Figure 5-7
5. Disconnect the front panel I/O device assembly cables from the system board as shown below.
Figure 5-8
6. Carefully guide the front panel I/O device assembly from the chassis.
ENWW
Removing the front bezel on page
Removing the front panel I/O device assembly
Disconnecting the front panel I/O cables
68).
Removing and installing components
69