Download  Print this page

Side Access Panel Sensor (optional); Removing The Side Access Panel Sensor; Installing The Side Access Panel Sensor - HP Z210 Maintenance And Service Manual

Convertible mini tower workstation.
Hide thumbs

Advertisement

Side access panel sensor (optional)

The side access panel sensor is a remote solenoid that detects when the side access panel is opened.
This section describes how to remove and install the sensor.

Removing the side access panel sensor

To remove the side access panel sensor:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Disconnect the sensor cable from the in-line chassis cable as shown below (1).
Figure 5-4
4.
Slide the sensor back in its slot, push the sensor down, and then remove it from the chassis (2).

Installing the side access panel sensor

To replace the side access panel sensor, reverse the previous steps.
66
Chapter 5 Replacing components
Removing the side access panel on page
Removing the side access panel sensor
Predisassembly procedures on page
62).
65).
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z210

Comments to this Manuals

Symbols: 0
Latest comments: