Disassembly order
For convenience, disassembly procedures should be followed in a particular order. Use the following
table to determine the sequence in which to access major workstation components.
Table 5-3
Workstation component installation
To install/replace...
Battery, front bezel, hard drive,
memory, power supply, rear
system fan, side access panel
sensor, or solenoid lock
Processor
Expansion card (PCI/PCIe)
Front panel I/O assembly, optical
bay filler, optical drive, power
button assembly, or system
speaker
System board
Removing the cable lock (optional)
If a cable lock is installed on the workstation, remove it before servicing the workstation.
ENWW
Remove...
Then
remove...
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Chassis lock
Side access
panel
Then
Then
remove...
remove...
Heatsink
Expansion card
Expansion card
support
slot cover
Front bezel
Expansion card
Expansion
support
cards or DIMMs
Removing and installing components
Then
remove...
Heatsink
63