Optical disk drive (mini-tower configuration)
This section describes how to remove and install an optical disk drive in the workstation mini-tower
configuration. For instructions on how to remove and install an optical disk drive in the workstation
desktop configuration, see
Removing an optical disk drive from the optical bay (mini-tower
configuration)
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Remove the front bezel (see
4.
Disconnect the data (1) and power (2) cables from the optical disk drive as shown in the following
figure.
Figure 5-10
ENWW
Optical disk drive (desktop configuration) on page
Removing the side access panel on page
Removing the front bezel on page
Disconnecting optical disk drive cables
Predisassembly procedures on page
68).
Removing and installing components
75.
62).
65).
71