Installing a DIMM
To install the DIMM:
1.
Disconnect power from the workstation (see
CAUTION:
unplug the power cord from the AC power outlet before removing or installing memory. The
workstation will not recognize the memory changes if the DIMM is damaged.
2.
Remove the side access panel (see
3.
Push gently outward on the DIMM socket levers as shown in the following figure.
Figure 5-26
ENWW
To prevent possible electrical damage to the DIMMs, power off the workstation and
Removing the side access panel on page
Opening DIMM socket levers
Predisassembly procedures on page
Removing and installing components
62).
65).
85