2.
Install the HDD into the mounting sled as shown in the following figure.
Figure 5-36
3.
Push the sled containing the HDD into the selected bay until it snaps into place (1) as shown in the
following figure.
Figure 5-37
4.
Attach a power cable (2) and a data cable (3) to the hard disk drive.
CAUTION:
use the HP-supplied data cable with right-angle connectors.
NOTE:
identify hard disk drive ports, refer to the workstation service label on the side access panel.
ENWW
Installing the HDD in the mounting sled
Installing the HDD drive
To avoid crushing or pinching the data cable when you replace the access panel,
Connect data cables to lower-numbered drive connectors first on the system board. To
Removing and installing components
97