Installing An Optical Drive (Desktop Configuration) - HP Z210 Maintenance And Service Manual

Installing an optical drive (desktop configuration)

1.
Disconnect power from the system (see
2. Remove the side access panel (see
3.
Remove the front bezel (see
4.
Remove the bezel blank from the drive bay you wish to use.
5. Remove the EMI filter panel from the drive bay you wish to use.
6.
Install the four black metric M3 guide screws into the drive (1).
Figure 5-18
7.
Align the screws with the grooves in the drive bay and gently slide the drive into the casing until it
snaps into place (2).
CAUTION:
be damaged if you move the workstation.
ENWW
Removing the side access panel on page
Removing the front bezel on page
Installing the optical drive
Pull on the drive to make sure it has snapped into place. If the drive is loose, it can
Predisassembly procedures on page
Removing and installing components
62),
65),
68),
77