Document Conventions - Cabletron Systems 9A656-04 Configuration Manual

Chapter 1: Introduction
Chapter 2, Basic System Configuration
Out-Of-Band, and SMB-10 IP Addresses, setting SNMP Community Names and SNMP
Traps, viewing chassis power supply information, creating PVCs and SPVCs, configuring
PNNI for the SmartSwitch 9500, setting ILMI parameters, configuring the management LEC,
and configuring the Environmental Module of the SmartSwitch 9500 chassis.
Chapter 3, ILMI 4.0 and the SmartSwitch 9500 System
SmartSwitch 9500 uses ILMI 4.0 to auto-configure signalling stacks and sides depending on
the requirements of the network, with no user input required.
Chapter 4, Signalling and Routing
MIBs to force individual interfaces to use specific Signalling stacks and sides, how to
configure an IISP interface via MIB tools, and provides a brief overview of PNNI 1.0 support
of the SmartSwitch 9500.
Appendix A, Acronyms
Appendix B, Default Settings
9500 system has upon first initialization, and cross references to sections of this manual where
these settings may be changed.
Appendix C, Supported MIBs
leaves supported by the SmartSwitch 9500 system.
1.2

DOCUMENT CONVENTIONS

The following conventions are used throughout this document:
Note symbol. Calls the reader's attention to any item of information that may be of
NOTE
special importance.
Caution symbol. Contains information essential to avoid damage to the equipment.
!
CAUTION
Tip symbol. Conveys helpful hints concerning procedures or actions.
TIP
Page 1-2
, provides instructions on setting the In-Band,
, provides information and instructions on how to use
, provides a list of acronyms commonly used in this document.
, provides information on the default settings the SmartSwitch
, provides tables that detail all of the MIB branches and branch
, provides information on how the
9A656-04/9A686-04 Configuration Guide