Configuring Iisp - Cabletron Systems 9A656-04 Configuration Manual

4.5

CONFIGURING IISP

The following subsections provide an example of configuring IISP.
This example describes how to set one side (the user side) of the IISP interface. For
NOTE
the interface to become fully operational, the same configuration must be take place
on the switch to which this switch will connect, the only difference being the other
switch's interface should be set up as the network side.
The steps required to configure the IISP interface are broken down as follows:
• Signalling Configuration
• Step 1: Setting the Signalling Stack Type
• Step 2: Setting the Signalling Side
• Step 3: Create and Configure a Reachable Address
9A656-04/9A686-04 Configuration Guide
(Section 4.5.1.1)
(Section 4.5.1.2)
(Section
Configuring IISP
4.6)
Page 4-11