16. Install the SAS controller front retention bracket that you got from step 15.
a. Align the retention bracket controller slot so that it faces the rear of the
b. Place the bracket tabs in the holes on the chassis and slide the bracket to
left until it clicks into place.
17. Remove the fillers (if they are installed) from the connectors on the M5015
adapters that come with the option kit.
18. Install one of the M5015 adapters:
a. Insert an M5015 adapter into the connector on the SAS riser-card.
b. Insert the front of the M5015 adapter into the front retention bracket.
Chapter 2. Installing optional devices