Moving the SAS controller retention bracket
Note: This procedure applies only to servers that have the following SAS
To move the SAS controller side retention bracket to a different position to
accommodate the dimensions of the current SAS ServeRAID controller, complete
the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server and all peripheral devices are turned off and that the
3. Remove the SAS riser-card assembly from the server (see "Removing the SAS
4. Remove the ServeRAID controller from the SAS riser-card.
PCI Express SAS
on page 37.
power cords and all external cables are disconnected.
riser-card and controller assembly" on page 117).
SATA tape signal
SAS riser card
(tape-enabled model server)
Chapter 2. Installing optional devices