Method 1: Begin Changing The Angle At The End Of Sewing By Pressing The "Reverse Stitch" Button - Brother Upgrade KIT III Operation Manual

Note
• Using the same material and stitch pattern as
your project, sew trial stitches to check the
result. If necessary, attach a stabilizer
material.
• If reinforcement stitches at the beginning and
end of sewing are needed, use
"Reinforcement Stitch" button. "Reverse
Stitch" button cannot be used for
reinforcement stitching when stitch tapering
function is on.
■ Method 1: Begin Changing the Angle
at the End of Sewing by Pressing the
"Reverse Stitch" Button
a
Touch , then
stitch pattern for stitch tapering.
b
If necessary, change the stitch width and
stitch length.
c
Touch , and then touch
UTILITY STITCHES AND CHARACTER/DECORATIVE STITCHES
, and then select a
.
d
Touch , select the angle settings for
the start and end of sewing, and then touch
.
a Select the start or end of sewing.
b Select an angle.
c Specify that the angle does not change.
e
Select the method for finishing sewing. For
this example, since the angle at the end of
sewing will begin changing when the
"Reverse Stitch" button is pressed, select
.
a Press the "Reverse Stitch" button for the angle at
the end of sewing to start changing; the machine
stops when sewing is finished.
b The machine stops when the specified number of
stitch patterns have been sewn. The number of
patterns that are specified includes the number of
patterns used to change the angle. (page 7)
c The machine stops at the position where the end
point sticker is affixed. (page 8)
a
b
c
a
b
c
6