Changing Thread Density (For Satin Stitch Patterns Only); Returning To The Beginning Of The Pattern - Brother 882-D30 Operation Manual

Memo
• To finish a complete motif while sewing the
pattern continuously, you can press the
key while sewing. The machine will
automatically stop when the motif is
finished.
Changing Thread Density
(for Satin Stitch Patterns Only)
After selecting a satin stitch pattern, press
select your preferred thread density.
CAUTION
• If the stitches bunch when thread density is
changed to , return the thread density to
. If you continue sewing when the stitches
are bunched, the needle may bend or break.
Memo
• Even if you select a new pattern after
changing the thread density, the thread
density remains the same until you change
it.
• You cannot change thread density for a
combined pattern after additional patterns
are added.
Returning to the Beginning of the
Pattern
When sewing character/decorative stitches, you
can return to the beginning of the pattern after trial
sewing or when the stitching is sewn incorrectly.
a
Press the "Start/Stop" button to stop the
machine, and then press
to
→ Sewing returns to the beginning of the selected
pattern ("W") from the point where sewing was
stopped.
b
Press the "Start/Stop" button to start
sewing from the beginning of the stitch
pattern ("W").
Memo
• Stitch patterns can be added at the end of a
combined stitch pattern, if you have
pressed
this example, "!" is added.)
EDITING STITCH PATTERNS
.
when sewing is stopped. (In
Sewing S-87
S
3