Changing Thread Density (For Satin Stitch Patterns Only); Returning To The Beginning Of The Pattern - Brother NQ3600D Operation Manual

Editing Stitch Patterns
Changing thread density (for satin stitch
patterns only)
After selecting a satin stitch pattern, press
screen to select your preferred thread density.
Low density ( )
CAUTION
• If the stitches bunch when thread density is
changed to , return the thread density to
. If you continue sewing when the stitches
are bunched, the needle may bend or break.
Memo
• Even if you select a new pattern after changing
the thread density, the thread density remains the
same until you change it.
• You cannot change thread density for a combined
pattern after additional patterns are added.
D-10
You can return to the beginning of the pattern after trial
sewing or when the stitching is sewn incorrectly.
on the editing
a
High density ( )
b

Returning to the beginning of the pattern

Press the "Start/Stop" button to stop the machine, and
then press on the editing screen.
 Sewing returns to the beginning of the selected
pattern ("W") from the point where sewing was
stopped.
Memo
• If this key is pressed when sewing is stopped,
patterns can be added at the end of a combined
stitch pattern. (In this example, "!" is added.)
Press the "Start/Stop" button to continue sewing.