Table of Contents
Advertisement
JunosE 11.3.x Quality of Service Configuration Guide
Meaning
334
host1#show qos-parameter references global brief
To display information about the parameter instances attached to a specific tunnel
interface, specify the interface at the root of the scheduler hierarchy located on the
tunnel-service interface or at the same hierarchy for LNS GRE tunnel traffic:
host1#show qos-parameter references tunnel-server 6/0
To display information about the parameter instancesattached to a specific L2TP session:
host1#show qos-parameter references l2tp-session session1
To display parameter instances only on the specified interface and not QoS parameters
stacked above the interface:
host1#show qos-parameter references gigabitEthernet 6/0 explicit
Table 56 on page 334 lists the show qos-parameter command output fields.
Table 56: show qos-parameter Output Fields
Field Name
interface
parameter name
value
source
service manager refs
persistence
Global parameter instances
Parameter instances reported
Field Description
Location of the interface to which the parameter
instance is assigned; global indicates that the
parameter is assigned to the chassis
Name of the parameter instance
Value assigned to the parameter instance
Source of the parameter instance:
dcm—Parameter instance was created in a profile
radius—Parameter instance was created through
RADIUS
service manager—Parameter instance was created
through Service Manager
default—Parameter instance was created through
the CLI or SNMP
Number of references of this parameter instance
created through Service Manager
Status of the persistence of a parameter instance in
the system:
persistent—Parameter instance is stored in NVS
and is restored after a chassis reset
non-persistent—Parameter instance is not stored
in NVS and are deleted after a chassis reset
Number of parameter instances assigned to the
chassis
Total number of parameter instances assigned
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
