Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual page 157

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
host1(config-qos-profile)#
(Optional) Configure a group node for each interface.
2.
host1(config-qos-profile)#atm group groupA scheduler-profile scheduler1
statistics-profile statpro-1
When you configure a group node, you can also reference a default or named
traffic-class group, a scheduler profile, or a statistics profile.
If you do not specify a traffic-class group, the group node defaults to the default group.
Each traffic class can belong to only one traffic-class group (either the default group
or a named group).
The router supports up to four traffic-class groups above a given port.
(Optional) Configure a scheduler node for interfaces.
3.
host1(config-qos-profile)#atm node scheduler-profile scheduler1 group strict-priority
When you configure a scheduler node, you can also reference a default or named
traffic-class group and a scheduler profile.
The scheduler profile supplies a relative weight and potentially a shaping rate to be
applied at the scheduler node.
NOTE: You cannot associate a scheduler profile with a port-type interface
unless you also specify the strict-priority group.
(Optional) Configure a queue for interfaces in the specified traffic class.
4.
host1(config-qos-profile)#atm queue traffic-class strict-priority scheduler-profile
scheduler1 queue-profile queue1 drop-profile drop1
When you configure a queue, you can include any of the following profiles:
The scheduler profile supplies a relative weight and potentially a shaping rate to
be applied at the queue.
The queue profile supplies threshold information for the queue if the router defaults
are not appropriate.
The drop profile supplies dropping behavior of a set of egress queues.
Each queue traffic class can appear in only one traffic-class group.
Attaching a QoS Profile to an Interface on page 128
Supported Interface Types for QoS Profiles on page 125
Configuring Shadow Nodes on page 144
Monitoring a Scheduler Hierarchy on an Interface with QoS Profiles on page 147
For information about configuring QoS profiles with Service Manager, see JunosE
Broadband Access Configuration Guide
group
Chapter 16: Configuring and Attaching QoS Profiles to an Interface
127