Configuring Interface Sets For Qos; Interface Sets For Qos Overview; Interface Set Terms - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

CHAPTER 23

Configuring Interface Sets for QoS

Interface Sets for QoS Overview

Interface Set Terms

Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure a set of logical interfaces with the same
scheduling and queuing properties using interface sets.
QoS topics are discussed in the following sections:
Interface Sets for QoS Overview on page 195
Architecture of Interface Sets for QoS on page 196
Configuring Interface Sets for Scheduling and Queuing on page 199
Configuring Interface Supersets for QoS on page 200
Configuring Interface Sets for QoS on page 201
Adding Member Interfaces to an Interface Set on page 202
Creating a QoS Parameter on an Interface Superset or Interface Set on page 204
Attaching a QoS Profile to an Interface Superset or an Interface Set on page 205
Deleting an Interface Superset or an Interface Set on page 207
Example: Configuring Interface Sets for 802.3ad Link Aggregation Groups on page 208
This topic describes how to use interface sets to configure a set of logical interfaces with
the same scheduling and queuing properties.
Interface sets are supported for VLANs, ATM VCs, and IP.
You can use interface sets for various scenarios in a broadband access network. For
example, you can use an interface set to configure a local loop with a small number of
subscribers. Interface sets are also useful for grouping a large number of subscribers into
a particular service class or for defining traffic engineering aggregates for DSLAMs.
Table 21 on page 196 lists the terminology used for interface sets
195