Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual page 346

JunosE 11.3.x Quality of Service Configuration Guide
vlan GigabitEthernet 11/0.2
ip GigabitEthernet 11/0.2
interface
---------------------------------
svlan GigabitEthernet 11/0 svlan 0
vlan GigabitEthernet 11/0.1
ip GigabitEthernet 11/0.1
vlan GigabitEthernet 11/0.2
ip GigabitEthernet 11/0.2
Queues reported:
Queues filtered (under threshold):
* Queues disabled (no rate period):
**Queues disabled (no resources):
Total queues: 5
316
5
0
0
0
In the output of this command, the aggregate of all drop rates—WRED, tail, and forwarding
events—is displayed in the aggregate drop rate field. You cannot distinguish among the
counters used for different drop rates from the output of this command. As a result, for
ES2 10G ADV LMs, you cannot identify the counters used for committed, conformed, and
exceeded packet dropping by WRED functionality from the value displayed in this field.
View the value displayed for the Dropped by WRED committed field in the output of the
show ip interface command to know the cumulative number of committed, conformed,
and exceeded packets dropped by WRED for ES2 10G ADV LMs.
To display rate statistics for the previous or current rate period:
host1#show egress-queue rates previous interface gigabitEthernet 11/0 svlan
0
host1#show egress-queue rates current interface gigabitEthernet 11/0 svlan
0
To display rate statistics for an L2TP session:
host1#show egress-queue rates l2tp session session1
To display rate statistics for a tunnel interface, specify the interface at the root of the
scheduler hierarchy located on the tunnel-service interface or at the same hierarchy for
LNS GRE tunnel traffic:
host1#show egress-queue rates tunnel-server 6/0
To display rate statistics for queues bound to the specified interface:
host1#show egress-queue rates interface gigabitEthernet 11/0 svlan 0 explicit
To display the sum of all rates of queues bound to interfaces that are stacked above the
specified interface.
host1#show egress-queue rates interface gigabitEthernet 11/0 svlan 0 summary
To display rate statistics for queues belonging to a specific traffic class:
host1#show egress-queue rates interface gigabitEthernet 11/0 svlan 0 traffic-class voice
To filter output based on the number of queues with rates that exceed the specified
value.
tc2 0
best-effort 0
maximum
rate
----------
1000000000
1000000000
1000000000
1000000000
1000000000
0
0
Copyright © 2010, Juniper Networks, Inc.
0
0