Configuring The Hrr Weight For A Scheduler Node Or Queue - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

JunosE 11.3.x Quality of Service Configuration Guide
Related
Documentation

Configuring the HRR Weight for a Scheduler Node or Queue

Related
Documentation
56
Static and Hierarchical Assured Rate Overview on page 53
Configuring a Scheduler Profile for a Scheduler Node or Queue on page 48
Configuring the HRR Weight for a Scheduler Node or Queue on page 56
For more information about specifying an expression that you can reference within a
scheduler profile, see Using Expressions for Bandwidth and Burst Values in a Scheduler
Profile on page 48
assured-rate
scheduler-profile
By default, the HRR weight is configured for the scheduler profile. You can set a specific
HRR weight of the scheduler node or queue. The weight value is used when no assured
rate is set.
To configure a static weight:
Create a scheduler profile.
1.
host1(config)#scheduler-profile relative
host1(config-scheduler-profile)#
Specify the weight value.
2.
host1(config-scheduler-profile)#weight 10
host1(config-scheduler-profile)#weight 800 - 200
The weight value is in the range 0-4080. The default weight is 8. Weight 0 (zero) is
a special weight that is used for relative strict-priority scheduling.
Use the operator and operandValue variables to configure a weight with an expression.
Static and Hierarchical Assured Rate Overview on page 53
For more information about specifying an expression that you can reference within a
scheduler profile, see Using Expressions for Bandwidth and Burst Values in a Scheduler
Profile on page 48
Relative Strict-Priority Scheduling Overview on page 58
scheduler-profile
weight
Copyright © 2010, Juniper Networks, Inc.