Deleting An Interface Superset Or An Interface Set; Deleting An Interface Superset; Deleting An Interface Set - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

Deleting an Interface Superset or an Interface Set

Deleting an Interface Superset

Deleting an Interface Set

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
You can delete an interface superset or an interface set after configuration.
Tasks to delete an interface superset or an interface set include:
Deleting an Interface Superset on page 207
Deleting an Interface Set on page 207
You must remove the interface sets from an interface superset before you can delete
the interface superset. If the interface superset has a QoS profile attached or a QoS
parameter instance, all of these attachments are also deleted.
To delete an interface superset:
Remove the interface sets from the interface superset.
1.
host1(config)#qos-interface-superset business-data
host1(config-qos-interface-superset)#no qos-interface-set atm-vc-data
Delete the interface superset.
2.
host1(config)#no qos-interface-superset business-data
You must remove the members of an interface set before you can delete the interface
set. If the interface set has a QoS profile attached or a QoS parameter instance, all of
these attachments are also deleted.
To delete an interface set:
Remove the interface set from the interface member.
1.
host1(config)#interface gigabitEthernet 4/0/0.1
host1(sub-if)#no qos-interface-parent vlan-business
Delete the interface set.
2.
host1(config)#no qos-interface-set vlan-business
For more information about deleting an interface set from an interface superset, see
Configuring Interface Supersets for QoS on page 200
For more information about deleting interface members of an interface set,
seeConfiguring Interface Sets for QoS on page 201
qos-interface-parent
qos-interface-set
qos-interface-superset
Chapter 23: Configuring Interface Sets for QoS
207