Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual page 316

JunosE 11.3.x Quality of Service Configuration Guide
Related
Documentation
286
host1(config-qos-parameter-define)#controlled-interface-type vlan
host1(config-qos-parameter-define)#controlled-interface-type ip
c. Configure subscriber-interface types.
host1(config-qos-parameter-define)#subscriber-interface-type vlan
Do one of the following:
3.
For VLANs, configure the shaping mode by creating a parameter definition with the
QoS cell mode application. Ensure that you specify a subscriber-interface type.
See "Configuring a Parameter Definition to Shape Ethernet Traffic Using Cell Mode"
on page 268.
For ATM VCs, configure the shaping mode by issuing the qos-shaping-mode
command.
See "Configuring the QoS Shaping Mode for ATM Interfaces" on page 166.
Enable QoS adaptive mode for the system by issuing the qos-adaptive-mode
4.
command in L2C Configuration mode.
host1(config)#l2c
host1(config-l2c)#qos-adaptive-mode
Enable the QoS downstream rate application to use downstream rates obtained from
5.
the Actual-Data-Rate-Downstream [26-130] DSL Forum VSA.
host1(config)#aaa qos downstream-rate
Configure the scheduler profile for the shaping rate.
6.
host1(config)#scheduler-profile vlan1
host1(config-scheduler-profile)#shared-shaping-rate downstreamVLAN * 5 auto
Configure the QoS profile for the shaping rate.
7.
host1(config)#qos-profile vlan1
host1(config-qos-profile)#vlan node scheduler-profile vlan1
Attach the QoS profile to a logical Ethernet interface.
8.
ANCP or AAA dynamically creates the parameter instances for the QoS downstream
rate application, and if applicable, the QoS cell mode application; therefore, you do
not need to specify them.
host1(config)#interface gigabitEthernet 6/0/2
host1(config-if)#encapsulation vlan
host1(config-if)#interface gigabitEthernet 6/0/2.1
host1(config-if)#vlan id 1
host1(config-if)#qos-profile vlan1
host1(config-if)#ip address 6.10.10.10 255.255.255.255
Example: QoS Parameter Configuration for QoS Downstream Rate on page 287
For information about downstream rate and RADIUS, see JunosE Broadband Access
Configuration Guide
Copyright © 2010, Juniper Networks, Inc.