Table of Contents
Advertisement
Meaning
Copyright © 2010, Juniper Networks, Inc.
host1#show egress-queue rates gigabitEthernet 1/0 rate-exceeding committed
host1#show egress-queue rates gigabitEthernet 1/0 rate-exceeding conformed
host1#show egress-queue rates gigabitEthernet 1/0 rate-exceeding exceeded
host1#show egress-queue rates gigabitEthernet 1/0 rate-exceeding forwarded
Table 44 on page 317 lists the show egress-queue rates command output fields.
Table 44: show egress-queue rates Output Fields
Field Name
interface
traffic class
forwarded rate
aggregate drop rate
committed drop rate
conformed drop rate
exceeded drop rate
minimum rate
maximum rate
Queues reported
Queues filtered (under threshold)
Queues disabled (no rate period)
Queues disabled (no resources)
Total queues
Chapter 31: Monitoring QoS on E Series Routers
Field Description
Name of the interface
Name of the traffic class
Statistics for the rate at which packets are enqueued.
In some time periods, the enqueue rate might exceed
the dequeue rate. This can occur when a burst of
traffic arrives at a queue which might be dequeuing
at a slower rate because of a shaper or congestion.
In other time periods, the enqueue rate might be less
than the dequeue rate. This can occur when a buffered
burst of packets are being dequeued, and no new
packets are arriving at the queue.
Total number of all drop rates
Drop rate for green packets
Drop rate for yellow packets
Drop rate for red packets
Minimum rate for queue
Maximum rate for queue
Number of queues reported
Number of queues not reported because they are
under the threshold
Number of queues not displayed because statistics
gathering is disabled (that is, the referenced statistics
profile does not have a rate period set)
Number of queues not displayed because no
resources were available
Total number of queues within the hierarchical scope
of the command
317
Advertisement
Table of Contents
Troubleshooting
