JunosE 11.3.x Quality of Service Configuration Guide
Configuring Traffic
Classes
Configuring the QoS
Parameter Definition
270
Figure 64: Byte Adjustment for VC1 and VC2
In Figure 64 on page 270, VLAN 1 and VLAN 2 map to the subscribers at VC1 and VC2.
The QoS administrator allocates a total of 10 Mbps of bandwidth for voice, video, and
data services to VC1, and 2 Mbps of bandwidth of data traffic for VC2.
Table 28 on page 270 lists the shaping rate and byte adjustment for both subscribers.
Table 28: Byte Adjustment for Subscribers VC1 and VC2
VC1
Protocol
A3 encapsulation
Byte Adjustment
-28
Voice Bandwidth
1000000 bps
Video Bandwidth
10000 bps
Data Bandwidth
8000000 bps
Total Bandwidth
–
The QoS administrator configures the traffic classes and traffic-class groups for video
and voice services.
Configure the traffic class named voice.
1.
host1(config)#traffic-class voice
host1(config-traffic-class)#exit
Configure the traffic class named video.
2.
host1(config)#traffic-class video
host1(config-traffic-class)#exit
The QoS administrator configures a parameter definition and the byte adjustment
application. The QoS administrator then enables the QoS client to create a parameter
instance of the byte adjustment from VLAN interfaces. All interfaces above the VLAN
use the same byte adjustment value.
Configure a parameter definition named byte-adjustment.
1.
VC2
A1 encapsulation
-2
1000000 bps
–
–
1000000 bps
Copyright © 2010, Juniper Networks, Inc.