JunosE 11.3.x Quality of Service Configuration Guide
Figure 45: Low-Latency Mode
162
To configure low-latency mode with a strict-priority queue and a best-effort queue:
Configure the traffic class.
1.
host1(config)#traffic-class strict
host1(config-traffic-class)#exit
Set the traffic class in the traffic-class group.
2.
host1(config)#traffic-class-group strict
host1(config-traffic-class-group)#traffic-class strict
host1(config-traffic-class-group)#exit
Define the scheduler profile for the traffic-class group.
3.
host1(config)#scheduler-profile strict
host1(config-scheduler-profile)#strict-priority
host1(config-scheduler-profile)#exit
Configure the QoS profile with two ATM VC queues.
4.
host1(config)#qos-profile low-latency-q-p
host1(config-qos-profile)#atm-vc node
host1(config-qos-profile)#atm-vc queue traffic-class best-effort
host1(config-qos-profile)#atm group strict scheduler-profile strict
host1(config-qos-profile)#atm-vc queue traffic-class strict
host1(config-qos-profile)#exit
From the desired port, set the QoS port mode to low latency.
5.
host1(config)#interface atm 2/0
host1(config-if)#qos-mode-port low-latency
host1(config-if)#qos-profile low-latency-q-p
Copyright © 2010, Juniper Networks, Inc.