Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual page 254

JunosE 11.3.x Quality of Service Configuration Guide
224
Several of the following tasks are optional. Perform the required tasks and also any
optional tasks that you need for your QoS parameter configuration.
To configure a parameter definition:
Create traffic classes.
1.
host1(config)#traffic-class business-data
host1(config-traffic-class)#exit
host1(config)#traffic-class voice
host1(config-traffic-class)#exit
host1(config)#traffic-class video
Create a parameter definition.
2.
a. Specify the parameter definition name.
host1(config)#qos-parameter-define max-subscriber-bandwidth
host1(config-qos-parameter-define)#
b. Specify the logical interface types for the nodes and queues controlled by this
parameter.
host1(config-qos-parameter-define)#controlled-interface-type atm-vc
host1(config-qos-parameter-define)#controlled-interface-type vlan
You can specify up to four of the following controlled-interface types per parameter
definition: atm, atm-vc, atm-vp, bridge, ethernet, fr-vc, ip, ip-tunnel, ipv6,
l2tp-session, l2tp-tunnel, lsp, pppoe, serial, server-port, vlan.
c. Specify the set of logical interfaces types upon which a QoS client can create
instances of the parameter.
host1(config-qos-parameter-define)#instance-interface-type atm-vc
host1(config-qos-parameter-define)#instance-interface-type ip
You can specify up to four of the following controlled-interface types per parameter
definition: atm, atm-vc, atm-vp, bridge, ethernet, fr-vc, ip, ip-tunnel, ipv6, lag,
l2tp-session, l2tp-tunnel, lsp, pppoe, serial, server-port, svlan, vlan.
d. (Optional) Specify the set of interface types that a QoS client can assign to a
parameter instance to represent subscribers.
host1(config-qos-parameter-define)#subscriber-interface-type ip
You can specify up to four of the following subscriber-interface types: atm-vc, ip,
ipv6, l2tp-session, vlan.
e. (Optional) Define the range of values that a QoS client can assign to a parameter
instance.
host1(config-qos-parameter-define)#range 64000 8000000
Reference the parameter within a scheduler profile parameter expression and configure
3.
an assured rate, shaping rate, shared-shaping rate, or weight.
host1(config)#scheduler-profile business-data
host1(config-scheduler-profile)#shaping-rate max-subscriber-bandwidth % 25
Add the scheduler profile to a QoS profile and configure the QoS profile.
4.
Copyright © 2010, Juniper Networks, Inc.