Switches the monitored picture between the remote and local sites." at the
bottom of the monitor.
Each press of the F1 button on the Remote Commander swaps the location of
both pictures.
To switch the display to the received RGB picture
When you receive an RGB computer picture from a remote party during
communication, pressing the LAYOUT button on the Remote Commander
displays the indication "F2: Switches to the RGB picture." at the bottom of the
monitor. The RGB picture is displayed by pressing the F2 button on the
Remote Commander.
To restore the previously displayed picture, press the F2 button again.
Switching the Video Output Equipment
While in communication, you can change the monitor or video equipment to
which the picture of the system is output.
1
Press the LAYOUT button on the Remote Commander.
The Layout menu appears.
2
Use the V, v, B or b button on the Remote Commander to select the
monitor select mode, then press the ENTER button.
HDMI: Outputs the picture to external equipment connected to the HDMI
OUT connector.
RGB: Outputs the picture to external equipment connected to the RGB
OUT connector.
HDMI+RGB: Outputs the picture to both equipment connected to the
HDMI OUT and RGB OUT connectors.
The picture outputs to the selected equipment.
3
To store the selected monitor mode in the memory of the system, use the
V, v, B or b button on the Remote Commander to select "Save", then press
the ENTER button.
The Layout menu disappears.
Switching the Picture Displayed on the Monitor Screen
123