Setting Phone Url Parameters For Midlets; Configuring A Remote Phone - Cisco CTS-500 Configuration Manual

Configuring a Remote Phone

If you are upgrading from an older XML specification identifier (XSI) user interface to MIDlets, you
Note
must reset the phone and reset the CTS to allow the Java MIDlets application to work with the
Cisco Unified IP Phone. See the
for reset information.

Setting Phone URL Parameters for MIDlets

Make sure the default services URL is set for MIDlets. To override default settings, follow these steps:
Log in to the Cisco Unified CM Administration interface.
Step 1
Choose System > Enterprise Parameters Configuration.
Step 2
In the Phone URL Parameters box, set the URL Services in the following format:
Step 3
http://xx.xx.xx.xx:8080/ccmcip/getservicesmenu.jsp
Where xx.xx.xx.xx is the IP address of the Cisco Unified CM server.
You may use a hostname providing the CTS is provisioned with a name server.
Note
Click Save to save your settings.
Step 4
Configuring a Remote Phone
To configure the system to use your CTS Cisco Unified IP phone remotely, follow these steps:
Log in to the Cisco Unified CM Administration interface.
Step 1
Navigate to Device > Phone and use the search fields to find the phone you wish to use remotely.
Step 2
Step 3 Write down the IP Address of your phone and CTS, and click the link under Device Name(Line) of your
phone, as shown in
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
2-18
"Managing Phone Reset and Codec Connectivity" section on page 3-11
Figure 2-1.
Chapter 2 Configuring the Cisco Unified IP Phone for MIDlets
OL-21851-01