Multiple Call/Call Waiting Settings On Device X; Forwarded Call Information Display On Device X; Step 1; Table - Cisco CTS-500 Configuration Manual

Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System

Multiple Call/Call Waiting Settings on Device X

The Multiple Call/Call Waiting settings make it possible to place a meeting on hold, dial a phone
number, and have up to four active calls on one device. This feature is useful for adding phone calls to
a Cisco TelePresence meeting.
The default setting for the maximum number of additional phone calls allowed on the CTS
Cisco Unified IP phone is 4.
Valid range for Maximum Number of calls is 1-46.
Note
To configure multiple call waiting settings on a specific device, follow these steps:

Step 1

Enter configuration settings in the fields provided using the information in
Step 2 Click Save to save your settings.

Table 1-22

Field

Maximum Number of Calls
Busy Trigger

Forwarded Call Information Display on Device X

Leave the following information unchanged in the Forwarded Call Information Display on Device X
Settings box:
•
•
•
•
OL-21851-01
Cisco TelePresence Device Multiple Call/Call Waiting Settings
Caller Name
Caller Number
Redirected Number
Dialed Number
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
Assigning a Directory Number to the Cisco TelePresence Device
Required? Setting
Yes Up to 4.
Yes 2 (Recommended)
Less than or equal to the maximum number of
Note
calls. By default, after two calls are started by
using OneTouch on the phone, a third attempt
at connecting to the IP phone results in a busy
signal.
Table 1-22 as a guide.
1-37