Configuring Ibm Domino For Cts-Manager - Cisco CTS-500 Configuration Manual

Configuring IBM Domino for CTS-Manager

Install and configure the Exchange 2007 server.
Step 1
Migrate the CTS-Manager User mailbox to the Exchange 2007 server.
Step 2
In CTS-Manager, go to Configure > Microsoft Exchange.
Step 3
Enter and apply the Exchange 2007 server configuration information. Once complete, the system will
Step 4
reboot.
After the system has rebooted, shut down the CTS-Manager server.
Step 5
This is important so that users do not use the CTS-Manager during migration.
Migrate all Cisco TelePresence endpoints to the Exchange 2007 server.
Step 6
Step 7 Verify that all Cisco TelePresence endpoints are of the type "RoomMailbox." This is required for
Auto-Accept to be enabled.
Step 8 After the migration is complete, add full access permission for the delegates to any proxy.
Configuring IBM Domino for CTS-Manager
Use the information in this section to create an account in IBM Domino for CTS-Manager.
The CTS-Manager LDAP user and system administrator need read permission to the Domino Directory.
Note
Use the information at the
Before You Begin
•
•
Procedure
To configure IBM Domino for CTS-Manager, follow these general steps:
Log into the CTS-Manager account once to verify that it is set up correctly.
Step 1
Set CTS-Manager account read and edit permissions for each resource reservation database that contains
Step 2
Cisco TelePresence room by doing the following:
a.
b.
Create a room resource in IBM Domino for each Cisco TelePresence or video conferencing room. Verify
Step 3
the following if applicable:
•
•
•
•
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
6-12
Lotus Domino 7 Administrator Help
Internet password for this account must be set.
Provide an adequate mailbox quota for the CTS-Manager account—Cisco recommends setting up
an account with at least 1 GB of mailbox quota for a deployment of up to 50 rooms.
Select the specific resource reservation database and right click to select Database > Access
Control.
Choose the account as specified below and set permissions per the instructions.
Create a new resource reservation database
Create a new site profile document
Add Cisco TelePresence rooms for Domino.
Create the Resource Reservation database.
Chapter 6 Setting Up the Room to Use Cisco TelePresence Manager
website for complete information.
OL-21851-01