Enabling One Phone Per Office; Monitoring The One Phone Per Office Feature; T1 Support Extended Reach - Cisco CTS-500 Configuration Manual

Chapter 5 Configuring MIDlets-Enabled Features
Step 2 Disable
mode.
For Cisco switch support information, see the
contact your system administrator.
See also the cdp-forward interface and show cdp-forward commands.

Enabling One Phone Per Office

For One Phone Per Office feature wiring information, see the Cisco TelePresence System Assembly, Use
Note
& Care, and Field Replaceable Unit Guide for your system on Cisco.com: 

Products > Cisco TelePresence > Cisco TelePresence System
To turn on the One-Phone Per Office feature, follow these steps in Cisco Unified Communications
Manager:
Step 1 Enable the PC Port in the
Step 2 Enable the speakerphone in the
Step 3 Choose Auto Answer Off in the
Step 4 See the
configured successfully on your system.

Monitoring the One Phone Per Office Feature

The One Phone Per Office feature runs automatically once it is configured on the system. To monitor the
feature, enter the show config phone command. In the following example, the Phone Connection shows
as "PC" rather instead of "Uplink," which indicates that the feature is successfully configured on the
system.
admin:show config phone
Phone Config
Phone Number
Phone IP
Phone Connection

T1 Support Extended Reach

The Quality per Display field in the
"High Detail, Limited Motion: 720p (Lite)" as part of the Extended Reach feature. Extended Reach
supports users in locations where bandwidth is costly or unreliable. Because internet bandwidth is not
dedicated, there may be experience issues or even call drops at certain times of the day due to a decrease
in available bandwidth. Extended Reach is directly related to the quality of the call.
OL-21851-01
BPDU by entering the spanning-tree bpduguard disable command in interface configuration
Product Specific Configuration Layout
Product Specific Configuration Layout
Directory Number Information
"Monitoring the One Phone Per Office Feature" section on page 5-3
: 23500
: 10.00.00.100
: PC
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
Product Support
Product Specific Configuration Layout
T1 Support Extended Reach
> Switches page on Cisco.com or
window.
window.
configuration fields for your device.
to check if the feature is
window has a new setting:
5-3