Cisco CTS-500 Configuration Manual page 160

Contents
Table C-1 Product Specific Configuration Fields
"More" Soft Key Timer
—
Auto Call Select
Yes
Log Server —
Advertise G.722 Codec Yes
Wideband Headset UI
Yes
Control
Wideband Headset
Yes
Peer Firmware
Yes
Sharing
Cisco Discovery
Yes
Protocol (CDP):
Switch Port
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
C-4
5 Revert the soft keys displayed to the initial set after you touch the more soft
key. The valid range of values for this timer are 5 to 30 -- indicating the number
of seconds before the softkey set reverts. A value of 0 may also be entered to
disable the timer. Maximum length: 2
Enabled Enables or disables the automatic call focus switching feature. When
"Enabled," the phone UI will automatically switch focus to certain calls on the
same line if no user interaction has occurred for 10 seconds. If "Disabled", the
phone UI will not automatically switch call focus. Disabling the Auto Call
Select feature automatically disables the Auto Line Select feature.
— Specifies an IP address and port of a remote system where log messages are
sent. Maximum length: 32
Use Indicates whether Cisco Unified IP Phones will advertise the G.722 codec to
System Cisco Unified Communications Manager. Codec negotiation involves two
Default steps:
1. The phone must advertise the supported codec(s) to Cisco Unified
Communications Manager (not all endpoints support the same set of
codecs).
2. When Cisco Unified Communications Manager gets the list of supported
codecs from all phones involved in the call attempt, it chooses a
commonly-supported codec based on various factors, including the region
pair setting.
Valid values specify Use System Default (this phone will defer to the setting
specified in the enterprise parameter, Advertise G.722 Codec), Disabled (this
phone will not advertise G.722 to Cisco Unified Communications Manager) or
Enabled (this phone will advertise G.722 to Cisco Unified Communications
Manager).
Enabled Users can enable or disable Wideband Headset option on phone user interface
(UI).
Enabled Enables or disables the use of a Wideband Headset on the phone. Used in
conjunction with User Control Wideband Headset.
Disabled PPID. Enables or disables Pee- to-Peer image distribution in order to allow a
single phone in a subnet to retrieve an image firmware file then distribute it to
its peers - thus reducing TFTP bandwidth and providing for a faster firmware
upgrade time.
Enabled Administrators can enable or disable Cisco Discovery Protocol (CDP) on the
switch port.
Warning CDP should only be disabled on the Network port if this phone is
connected to a non-Cisco switch.
Appendix C Product Specific Configuration Layout Help
OL-13677-05