Table of Contents
Advertisement
Chapter 1
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Configuring the Options File
Cisco Unified CM is customized with an options file to configure support for the Cisco TelePresence
system (CTS).
To configure the options file, follow these steps:
Step 1
Log in to the Cisco Unified CM Administration interface. See the
Administrator" section on page
Step 2
Add the Cisco TelePresence device pack to Cisco Unified CM. The device pack adds functionality to
Cisco Unified Communications Manager so that you can create a Cisco TelePresence device. See the
"Adding a Cisco TelePresence Device" section on page
Create a Cisco TelePresence device to register the Cisco TelePresence device as a Cisco Unified IP
Step 3
Phone. See the
Assign a directory number to the Cisco TelePresence device. See the
Step 4
the Cisco TelePresence Device" section on page
Step 5
Create a Cisco Unified IP Phone 7975 device type. See the
in
Chapter 2, "Configuring the Cisco Unified IP Phone for MIDlets."
Auto registration cannot be used to create the device type.
Note
OL-21851-01
1-2.
"Creating a New Cisco TelePresence Device" section on page
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
"Logging into the Cisco Unified CM
1-4.
"Assigning a Directory Number to
1-30.
"Managing Cisco Unified IP Phones"
Configuring the Options File
1-5.
section
1-3
Advertisement
Chapters
Table of Contents
