Snmp Configuration Parameters - Cisco CTS-500 Configuration Manual

Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System

SNMP Configuration Parameters

Using the information in
Protocol (SNMP) configuration parameters for accessing the SNMP server that is associated with the
Cisco TelePresence device.
See
Note
information about managing your SNMP configuration. 

Passwords in SNMP parameter fields can only be 32 characters in length.
Figure 1-5
Note All SNMP fields are marked to reflect the applicable SNMP version.
Table 1-10 Cisco TelePresence SNMP Configuration Parameters
Field
Enable SNMP
SNMP (v3) Security Level
OL-21851-01
Table 1-10
Figure 1-5
Appendix A, "MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System"
SNMP Configuration Parameters
Required? Setting
Yes Enables or disables SNMP on the CTS. SNMP must be enabled for the
Cisco TelePresence system to support SNMP. Options include the following:
• Disabled (default)
• Enabled (v3)
• Enabled (v3/v2)
• Enabled (v2c)
Note
Yes Level of security supported by the SNMP user. This field is only used for
SNMP v3. Choose from the following security levels:
• (v3) Authentication, No Privacy
(v3) Authentication, Privacy
•
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
as a guide, provide the required Simple Network Management
shows the SNMP Configuration Parameters screen.
SNMP username is automatically configured by the system as
"admin."
Configuring a Cisco TelePresence Device
for more
1-23