Auxiliary Control Unit; Dial Plan Information - Cisco CTS-500 Configuration Manual

Configuring a Cisco TelePresence Device

Auxiliary Control Unit

Required if installed. Select the appropriate option for Auxiliary Control Unit Power Control:
•
•
•
See the
system. See also the
about hardware options.
Note The CTS 1100 and the CTS 1300 use the Auxiliary Control Unit by default.
Notes About Auxiliary Control
•
•

Dial Plan Information

Provide dial plan information for the Cisco TelePresence device using the descriptions in
Click Save to save your settings.
Only numeric values are allowed.
Tip
Table 1-5 Cisco TelePresence Dial Plan Information
Field
Site Access Code
Inter Site Access Code
Off-Net Access Code
National Dialing Digits
International Dialing Digits —
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-18
Chapter 1
On with calls only. See Notes About Auxiliary
On with display settings
On all the time
"Product Specific Configuration Layout" section on page 1-10
Cisco TelePresence Hardware Options and Upgrade Guide
Auxiliary Video Input—On some systems auxiliary video input may be displayed on the primary
65-inch main screen even when the auxiliary LCD display is powered off or is disconnected from
the presentation codec.
Ensure that the Auxiliary LCD display is powered on and connected at all times. If the display has
a setting to power off automatically after a certain number of minutes of inactivity, disable that
feature to ensure that the display stays powered on and connected. See your LCD user manual.
Auxiliary Power Control: On With Calls Only—On some systems when Power Control is
configured for "On with calls only" and there is an Auxiliary HDMI port connected (Active Display
or Projector), the lights will remain on for 5 minutes after the call has been terminated. If no
Auxiliary HDMI port is in use, the lights will go off immediately.
Required? Description
— Specifies the access code of this site (cluster). Maximum field length is 6.
— Specifies the access code to dial another site (cluster). Maximum field length is 6.
— Specifies the access code to dial outside of the network (PSTN). Maximum field
length is 3.
— Specifies the digits dialed to place a national call. Maximum field length is 6.
Specifies the digits dialed to place an international call. Maximum field length is 6.
Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Control.
to find the default values for your
for more information
Table
OL-21851-01
1-5.