Prerequisites - Cisco CTS-500 Configuration Manual

Configuring Cisco Unified CM for Cisco TelePresence Manager
•
•
•
•

Prerequisites

Before you proceed with the CTS Manager installation, the servers and applications within your network
must be configured so that Cisco TelePresence Manager can find the resources and information needed
to initialize the installation. Cisco Unified Communications Manager Release 7.0.2 or a later release
software should already be installed and configured. For more information refer to
"Configuring Cisco Unified Communications Manager for the Cisco TelePresence System."
Note Cisco recommends that you configure the system using static IP addressing so it will be easy to manage.
If you see the test connection failure message in a non-DNS environment, you may need to specify IP
addresses for your Cisco Unified CM server(s) and other network devices. You can change any server
name values in Cisco Unified Communications Manager. See the
Server Names" section on page
Pre-Configuration Guidelines for Running Cisco Unified CM with CTS Manager
Table 6-2
Note The system uses either Microsoft Exchange or IBM Domino to schedule meetings. See the
Microsoft Exchange for CTS Manager" section on page
Table 6-2 Guidelines for Setting Up Cisco Unified CM for CTS-Manager
Set-Up Guidelines Before
Installing CTS-Manager
Configuring Cisco Unified CM
Install and Configure the
Pre-Qualification Assistant
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
6-14
Adding a Cisco TelePresence Device, page 6-18
Downloading Device Packs, page 6-19
Installing the Device, page 6-19
Testing Cisco Unified CM with the Pre-Qualification Assistant, page 6-20
contains guidelines for pre-configuring Cisco Unified CM to run Cisco TelePresence Manager.
Description
Verify that Cisco Unified CM is configured for the
CTS-Manager system.
Install and run the
Assistant to ensure that your pre-installation
set-up is configured correctly. The data you enter
into the Tool Test Configuration forms are used to
verify connections to the servers and retrieve data
from them to be used to configure CTS Manager.
Chapter 6 Setting Up the Room to Use Cisco TelePresence Manager
6-17.
CTS Manager PreQualification
"Configuring Cisco Unified CM
6-4.
Location
See the "Configuring Cisco Unified
CM for Cisco TelePresence Manager"
section on page 6-13.
See the Cisco TelePresence System
Manager home page on Cisco.com for
instructions and support
documentation.
Chapter 1,
"Configuring
OL-21851-01