Cisco CTS-500 Configuration Manual page 44

Configuring a Cisco TelePresence Device
Table 1-10 Cisco TelePresence SNMP Configuration Parameters (continued)
Field
SNMP (v3) Auth. Algorithm
SNMP (v3) Auth. Password
SNMP (v3) Privacy Algorithm
SNMP (v3) Privacy Password
SNMP System Location
SNMP System Contact
SNMP (v2c) Community Read
Only
SNMP (v2c) Community Read
Write
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
1-24
Chapter 1 Configuring Cisco Unified Communications Manager for the Cisco TelePresence System
Required? Setting
Yes Authentication algorithm supported by the SNMP user. This field is only used
for SNMP v3. Choose from the following algorithms:
MD5—Message-Digest algorithm 5
•
SHA—Secure Hash Algorithm
•
Yes SNMP administration user authentication password used to gain access to the
SNMP v3 server associated with the Cisco TelePresence system. Default
password is snmppassword.
Maximum field length is 32 characters.
•
Minimum field length is 8 characters.
•
Yes Privacy algorithm supported by the SNMP user. This field is only used for
SNMP v3. Choose from the following privacy algorithms:
DES—Data Encryption Standard
•
• AES—Advanced Encryption Standard
Yes SNMP administration privacy password used to gain access via SNMP v3 on
the Cisco TelePresence system. Default password is snmppassword.
• Maximum field length is 32 characters.
• Minimum field length is 8 characters.
Yes SNMP System Location associated with this Cisco TelePresence system.
Maximum field length is 64 characters.
Default is Location.
Yes Name of the SNMP system contact associated with this Cisco TelePresence
system. Maximum field length is 64 characters.
Default is Contact.
Yes SNMP community strings authenticate access to MIB objects and function as
embedded passwords. Read-only gives read access to authorized management
stations to all objects in the MIB except the community strings, but does not
allow write access. This field is only used for SNMP v2c.
Default is readonly.
Yes SNMP community strings authenticate access to MIB objects and function as
embedded passwords. Read-write gives read and write access to authorized
management stations to all objects in the MIB, but does not allow access to
the community strings. This field is only used for SNMP v2c.
Default is readwrite.
OL-21851-01