Setting Ietf Radius Parameters For A User - Cisco 2509 - Router - EN User Manual

Advanced User Authentication Settings

Setting IETF RADIUS Parameters for a User

Note
Note
User Guide for Cisco Secure ACS for Windows Server
7-38
Setting Cisco VPN 5000 Concentrator RADIUS Parameters for a User,
•
page 7-45
Setting Microsoft RADIUS Parameters for a User, page 7-46
•
Setting Nortel RADIUS Parameters for a User, page 7-48
•
Setting Juniper RADIUS Parameters for a User, page 7-49
•
• Setting BBSM RADIUS Parameters for a User, page 7-51
To configure custom VSAs, see
page 7-52.
RADIUS attributes are sent as a profile for the user from Cisco Secure ACS to the
requesting AAA client.
These parameters display only if all the following are true:
• A AAA client has been configured to use one of the RADIUS protocols in
Network Configuration.
• The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.
• User-level IETF RADIUS attributes have been enabled under RADIUS
(IETF) in the Interface Configuration section.
To display or hide any of these attributes in the HTML interface, see
Configuration Options for RADIUS, page
For a list and explanation of RADIUS attributes, see
Attributes," or the documentation for your particular network device using
RADIUS.
Chapter 7 Setting Up and Managing User Accounts
Setting Custom RADIUS Attributes for a User,
3-10.
Appendix C, "RADIUS
Protocol
78-14696-01, Version 3.1