Peripheral Status Messages - Cisco CTS-500 Configuration Manual

Peripheral Status Messages

Peripheral Status Messages
Table A-3
Table A-3 Peripheral Status
Notification
ctpPeripheralDescription
ctpPeripheralCableCode
ctpPeripheralPowerCode
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
A-4
Appendix A
lists peripheral status messages.
Return Values
This object specifies a description of the attached peripheral. Peripheral description
may be the peripheral type, model and/or version information or a peripheral signal
description.
Reports the following system details:
• Projector Product ID
• IP Phone MIDlet information
Phone load and MIDlet version for phone status
•
The textual convention identifies cable status of the attached peripheral through
HDMI.
plugged (1)—Peripheral cable is plugged.
•
loose (2)—Peripheral cable is loose.
•
unplugged (3)—Peripheral cable is unplugged.
•
unknown (4)—Cannot detect peripheral cable status.
•
• internalError (5)—Internal error.
The textual convention identifies power status of the attached peripheral through
HDMI:
• on (1)—Peripheral power is on.
• standby (2)—Peripheral power is in standby mode.
• off (3)—Peripheral power is off.
• unknown (4)—Cannot detect peripheral power status.
• internalError (5)—Internal error.
MIBs, RFCs, and SNMP Trap Messages for the Cisco TelePresence System
OL-21851-01